威海浩威户外用品有限公司

The rubber boat after use can not be used without deflating it? Every time you use the gas released, the second time to use again to re-inflate, play a gas at least half an hour, quite a hassle, this problem should be the majority of rubber boat enthusiasts trouble. Rubber boat originated in North America on Greenland Eskimos with animal skin wrapped in a wooden frame to make the animal skin boat. The kayak has a rudder, when the race, athletes sitting in the boat, facing forward, holding two paddles with paddle blades on both sides of the boat in turn paddling, relying on the foot to manipulate the rudder to control the course. There are single boats, double boats, four-person boats and obstacle slalom project. Charge boat is a kind of inflatable boat, divided into glass and steel plate and rubber boat type of charge boat, modern inflatable charge boat is mainly used for government agencies to carry out maritime tasks more, easy to transport easy to install and use, now become a kind of folk for recreational equipment. Rubber boats are mostly used for life-saving, fishing and recreation. The emergence of the assault boat mainly lies in its speed. Rubber boat manufacturing kayak materials are: wooden plywood, plywood, aluminum, fiberglass, plastic, etc.. Internationally, there are uniform regulations on the length, width and minimum weight of race boats to facilitate fair competition. Within this regulation, the manufacturer plays its design level to make the athletes get good results in the race as much as possible. Of course, to win or not, mainly from the flexibility of the athlete's skills and the use of power.

Rubber boat production materials are made of rubber, rubber in normal conditions it is a good elasticity and impermeable to air materials, with a high elongation, up to 5 times its own. Rubber boats in the case of full of gas will make their own rubber material elongation more than double, if you do not deflate the rubber boat after use and long time without, so that the rubber to maintain the state of tension expansion will accelerate the aging of rubber, after deflating back to the prototype. In order to increase the life of the rubber boat, and maximize the reduction of each time the trouble brought about by the gas, it is recommended that after each use of the rubber boat, the gas will be released 30 ﹪, in this case, the airflow is not full, the rubber will not accelerate aging due to tension and expansion, and can reduce your next inflatable time, the best of both worlds!